Model #10658282890 KENMORE Side-by-Side Refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Refrigerator Shelf
    3 Results
  • Freezer Liner
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Air Flow
    3 Results
  • Control
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Which parts to replace and how on this dispenser for a water leak?

A:

For a constant drip the water valve # 4389177 will need to be replaced. This valve is located behind the refrigerator. Before replacing this valve be sure to disconnect the power from the unit and shut the water supply valve off. If this is an occasional drip, it indicates there is air in the line. For this type of drip use check valve # 2314271. This is a fitting that will connect to the water line under the freezer door. These parts are available at www.searspartsdirect.com . If you need more assistance you can resubmit your question with more details.

Read More
Scott D -
Sears Technician
February 24, 2009
A:

I need to know how to replace the tube inside the frezer door to the wter dispencer on model 10658252890

Read More
DeWitt -
April 21, 2014
A:

I need to know how to replace the tube inside the frezer door to the wter dispencer on model 10658282890

Read More
DeWitt -
April 21, 2014
See more answers
Q:

Water dispenser on refrigerator is not working.

A:

It can be very frustrating when the dispenser on your refrigerator begins to malfunction. I did some research and provided a link to a similar question and answer on our site. I hope this will shed a little more light on the issue until the Expert responds to your question in more detail within 24 to 48 hours.

Read More
Julio -
October 25, 2012
A:

Thank you for your question. I know it can be disappointing when the water dispenser stops working. This could be a problem with the water valve but a lot of times the problem is in the dispenser with the switch. A good check will be to, press the lever in slowly and listen for a clicking sound. If you do not hear this sound, it indicates that either the switch has failed or the actuator is not making contact with it. The switch and actuator can be checked by removing the front cover (see image). Be sure to disconnect the power first. If you do hear a clicking sound and if you can also hear a humming sound from the back of the cabinet, it will indicate the water valve is being energized. This will usually mean the water valve # W10408179 is not opening and will need to be replaced. It�s located behind the cabinet. Remove the back panel cover and you will be able to see and access the valve. The water supply line will connect to the valve. I hope this will help you. If you would like more assistance, reply to this thread and I will assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
October 26, 2012
See more answers
Q:

Refrigerator model 10658282890, cap for filter can't turn vertical when installing filter

A:

If you choose to schedule service while your waiting for an expert to respond you could visit the Sears Home Services website. I have attached the link below.

Read More
Jackie S -
February 21, 2011
A:

I understand your concern about this filter. The filter has been redesigned to give it more strength. However, now it can be more difficult to get in the housing all the way and turn it. Make sure it's pushed in all the way. It can be tight but it will fit and turn. More pressure may be needed. I hope this will help you. Thank you for using Manage My Life.

Read More
Scott D -
Sears Technician
February 22, 2011
See more answers

Top Parts