Model #10657993700 KENMORE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

how do i access control board on my kenmore refrigerator

A:

Replacing a major part on your refrigerator consists of some detailed instructions. While you are waiting for an expert answer, I did manage to find a great link that will provide guidance in doing your project. I hope my link is useful.

Read More
Joseph P. -
January 08, 2011
A:

Replacing some parts can be a little tricky sometimes. The information you have already received is good but this model will be slightly different. To lower this control panel, first disconnect power to the unit. Now, pull the control knobs off and remove the front escutcheon. With the escutcheon off, you will have access to some screws that will need to be removed. Also remove the back screws from the control. You should be able to pry the front side tabs loose now and lower the control housing. I hope this will help you. If you would like more assistance, any additional details will be helpful and I will be glad to assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
January 11, 2011
A:

Original problem was freezer not defrosting, and frig got warm. I was able to remove the control housing and installed the new electronic control circuit board. The green water filter status light is now steady green, it was flashing before I replaced the board. I also defrosted the freezer coils with a hair dryer and so far the refrigerator side is staying cool. Hopefully the defrost cycle is now working in the freezer. New problem: The ice maker is not making ice. Water dispenser works. Could the ice maker water line be frozen? Thanks

Read More
jimwoodman -
January 11, 2011
A:

Yes, the water line could be frozen. If you cannot see the water tube, then the icemaker will need to be removed. To remove the icemaker, loosen the 2 top screws above the mold and remove the screw under the mold (see picture). It will now be free to lift off the top screws and lower it. If the fill tube is frozen, use a hair dryer to thaw it out. Just be careful not to get it too hot. The water valve # 4389177 will also need to be replaced to correct this problem. The valve is available at the link listed below. I hope this will help you.

Read More
Scott D -
Sears Technician
January 11, 2011
A:

Water line was not frozen. Ice was jammed in the ice mold. This stopped motor. Works fine now. Thanks for the help.

Read More
jimwoodman -
January 12, 2011
See more answers

Top Parts