Model #10657036602 KENMORE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Refrigerator Shelf Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

need water filter and shelf 106.57036602

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help you with your refrigerator. Upon researching model 106.57036602;  I have posted a link below  of the filter and the self-standing  glass shelf.

Click here to view the filter.

Click here to view the shelf.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
June 11, 2015
Q:

Side by Side fridge freezing up

A:

Thank you for choosing ManageMyLife.com. I understand how frustrating it can be when the refrigerator keeps getting too cold. First, make sure that the temperatures are at the correct setting. You can test your thermostat by following the instructions below.
SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

1. Unplug your refrigerator. Next, locate the control panel where the thermostat is located and remove all of the items near it so you can work. The thermostat is located directly behind the dial. You may need the flashlight to help you see inside the refrigerator.

2. Remove the plastic cover that protects the controls. Some covers are screwed into place while others are held in place by plastic clips. Depending on your make and model refrigerator, you may have to first remove the dial before you can take the cover off.

3. Turn the dial to the coldest setting. Remove the two leads (wires) on the thermostat.
Note: It helps to write down which lead goes where for when it's time to replace everything.

4. Set the volt-ohm multimeter to RX1 and probe the terminals. By "probe," I mean touch one of the multimeter's probes to one terminal on the thermostat and the other probe to the other terminal. You should be getting a reading of zero. If you get a zero reading, then move on to Step 6. If you do not get a zero reading, then remove the thermostat and take it to an appliance store for a replacement.

5. Remove the thermostat from the refrigerator entirely. Set the dial on the thermostat to the warmest setting and place the thermostat in a working freezer for 30 minutes. After the 30 minutes are up, reprobe the terminals and look for a reading of infinity. If you get the infinity reading, then the thermostat is fine. Simply reinstall it, plug the refrigerator back in and look for another cause of your freezing problem, like dirty coils. If you do not get an infinity reading (sideways "eight"), you should replace the thermostat with a new one.

Also, since you mentioned the drastic change in outside temperature, I recommend checking for leaks in the gasket that will cause the refrigerator to continuously run. Test the refrigerator gasket with the power connected, if desired. Open the door and place a piece of paper or dollar in the door gap, between the metal and the rubber gasket lining the inside of the door. Close the door and tug at the paper. Resistance from the door seal indicates no gap or leak in that portion of the door. Repeat the testing procedure all along the perimeter of both the door to the refrigerator and to the freezer. Any areas where the paper easily pulls out from the door have a leak or gap in the gasket.
If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services
If you would like more assistance, reply to this thread and please include more symptoms if possible (i.e. is compressor running constantly?). I would be glad to assist you further. Thanks for using ManageMyLife.com.

Read More
Lokelani -
Sears Technician
August 25, 2013
Q:

We have a 5 year old refrigerator that we are trying to find a part for.

A:

Finding parts can be frustrating sometimes. The manufacturer does sometimes sell parts only as an assembly. I did find the parts schematic for the ice maker. I am adding the link below to help you with your question while you wait for your expert response. It may take your expert 24-48 hours. I do hope that this will help you with your ice maker.

Read More
Marc H -
June 05, 2012
A:

Thanks for the response, but the website seems to be different than the one I went to. I don't see the part we need. Guess I'll keep searching.

Read More
Tammy -
June 06, 2012
A:

I know that it can be very difficult to have issues with your refrigerator. I am a little confused about the part that you need. If you are looking for the ice bin, this is available both individually and as a complete assembly. You do not need to replace the whole door for this. However, if the broken part is not the bin, but where the bin sits at on the door, then yes you would need to replace the whole door. If you would like to view and order parts, just click on this link: Sears Parts Direct . If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
June 06, 2012
See more answers

Top Parts