Model #10657029602 KENMORE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Refrigerator Shelf Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore Refrigerator - 106.57029602 - BAD Tasting Water

A:

I understand your issue, i did find a similar question like yours. An expert answered read it and it might give you an idea on how to repair your issue, while you wait for an expert to answer your specific question, good luck.

Read More
celene -
September 01, 2010
A:

celene....did you get the parts to replace this or have a technician do it? If you did it, is there a kit for this? I don't need someone to do it, the water lines are very straight forward.

Read More
fitfestus -
September 01, 2010
A:

This problem usually occurs when a plastic water supply line is used. The plastic line needs to be replaced with copper and I would also recommend replacing the reservoir # 2256126. The reservoir can absorb an odor and then transfer it, to the water inside of it. It's possible the water line # 8201537 in the door may need to be replaced also but it's rare that this line needs replacing. These parts are available at SearsPartsDirect . If you need more assistance, additional details will be needed.

Read More
Scott D -
Sears Technician
September 02, 2010
See more answers
Q:

Sears Side by Side #106.57029602 ice maker is not working...red light flashing...Water line is working fine.

A:

If the red led light is blinking twice then pauses and continues this pattern while the door is open, it indicates the boards are working ok. There are some test terminals on the front module of this icemaker, that may help determine the problem. To access the module, pull the front cover off of the icemaker. The icemaker will need to be lowered to get the front cover off. It will have 4 screws under the icemaker and a clip on the back right corner, that needs to be removed. Close the front flapper door and the icemaker will slide out now. With the cover off, you will see the terminals and they will be marked. Now close and tape the flapper door to keep it closed. Place a well insulated jumper between the L - V terminals but be careful, this is a hot (live) check. With the jumper in place, water should flow to the icemaker. If water does flow, the icemaker will need to be replaced. If no water flows but you can hear a buzzing noise, the water valve will need to be replaced. If nothing happens, some voltage checks will need to be made. If you need more assistance, please resubmit your question, with additional details.

Read More
Scott D -
Sears Technician
May 10, 2010

Top Parts