Model #10656864600 KENMORE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Refrigerator Shelf Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

defrost timer Kenmore Side by side refrigerator

A:

Thank you for choosing SearsPartsDirect.com. Thank you for your question. I can understand how upsetting a warm fridge section can be. The freezer section cools the fresh food section also so if the fresh food section is not cooling here are a few things you can check yourself.

Look into the very back of the freezer section, the back panel should not have a thick coating of frost on it, if it does then the unit is not defrosting properly and will need service.

Check that the fan motor in the freezer section is running and you can hear air movement, you should hear this any time the compressor is running. Last if the freezer control knob is set to the highest setting the air to the fresh food section is greatly restricted and should be set mid-way.

If there is no frost and the fan is running, the most likely problem will be a frozen return air vent. A good check for this will be to feel the air flow from the diffuser and while checking it, open the freezer door. If the air flow increases, it indicates the return vent is frozen. In this case, again turn the unit off for 24 hours to allow the vent to thaw out.

If you would like a Sears technician to complete the repair, you can set up service at www.SearsHomeServices.com or by calling 1-800-469-4663.

Have a great day.

Read More
Samantha A -
Sears Technician
May 20, 2014
Q:

Kenmore model 106.56864600. . ice maker

A:

Now a days we wish everything was manually. While you are waiting on an expert to answer your question, a suggestion I have is to go over your owner's manual. I have found your manual in the Manage My Life website I have attached the link below. Hope this helps!

Read More
Dezeray S -
February 01, 2011
A:

Thanks, but I have done all this. The ice is frozen and appears ready to cycle, but nothing is happening. This started with it getting stuck witha piece of ice which I removed and the ice maker dumped, filled , etc.,but now it appears to be doing nothing. Any suggestions?

Read More
Charles -
February 01, 2011
A:

Having an icemaker is a great feature but can be disappointing when it fails. The icemaker in this model can stop working for a few reasons. Some are listed below:

  • The icemaker itself can fail
  • The water valve may not open
  • The optic boards can fail
  • The fill tube can freeze up
  • Freezer temperature not cold enough (should be 0 � 5 degrees)
The blinking led light can be flashing a code that will indicate the problem. If it flashes 2 times pauses and continues this while the door is open, it�s normal. Now disconnect power to the refrigerator. To check this icemaker, slide it out, so the front cover can be removed, to access some test terminals. There is a clip located on the back right corner of the icemaker that will need to be removed, to slide the icemaker out. There will be a screw at the bottom of the clip holding it. I�m sending a picture with instructions to remove this clip. With the clip removed, slide the icemaker out and remove the front cover. You will now see the test terminals, which are marked (see picture). Now remove the 3 screws holding the receiver board on the right side and disconnect the harness from the board. Place a jumper between the black and black/white wires (see picture). Now use a second jumper and place it between the L � V terminals on the module. Reconnect the power and with both jumpers in place, water should now flow to the icemaker (be prepared to catch water from the fill tube). If water does flow, the icemaker # 2212352 will need to be replaced. If no water flows but you can hear a humming noise, the water valve # 4389178 will need to be replaced. If nothing at all happens, some voltage checks will need to be made. I hope this will help you.

If you do not feel confident repairing this problem or doing any voltage checks yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services . If you need more assistance additional details will be helpful.

Safety Notice: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Scott D -
Sears Technician
February 02, 2011
A:

I can handle this. Thanks for the information.

Read More
Charles -
February 02, 2011
See more answers

Top Parts