Model #10656703500 KENMORE ELITE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Refrigerator Shelf Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Optional Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

my kenmore refrigerator (model#106.56703500) is not making ice. the water dispenser is working. the sensor light is blinking twice

A:

I found some information for you that I am hoping will be able to help you. Please click here:[Ice Maker Not Working]. Your expert will also help answer your question. It may take two business days for your expert to reply. I do hope that everything works out.

Read More
Marc -
May 15, 2013
A:

Thank you for your question. I know it can be disappointing when the icemaker stops working.

The icemaker in this model can stop working for a few reasons. Some are listed below:

*The icemaker itself can fail

*The water valve may not open

*The optic boards can fail

*The fill tube can freeze up

*Freezer temperature not cold enough (should be 0 – 5 degrees)

The blinking led light can be flashing a code that will indicate the problem. If it flashes 2 times pauses and continues this while the door is open, it will be normal and if it stays on continuous, when the flapper door on the left side is held in, it indicates the boards are ok. I’m attaching a chart for the led indicator. When checking this icemaker, tape the little flapper door shut and disconnect power to the refrigerator. To check this icemaker, slide it out, so the front cover can be removed, to access some test terminals. There is a clip located on the back right corner of the icemaker that will need to be removed, to slide the icemaker out. There will be a screw at the bottom of the clip holding it. I’m sending a picture with instructions to remove this clip. With the clip removed, slide the icemaker out and remove the front cover. You will now see the test terminals, which are marked (see picture). Now remove the 3 screws holding the receiver board on the right side pull the board out and disconnect the harness from the board. Place a jumper between the black and black/white wires (see picture). Now use a second jumper and place it between the L – V terminals on the module. Reconnect the power and with both jumpers in place, water should now flow to the icemaker (be prepared to catch water from the fill tube). If water does flow, the icemaker # 2198597 will need to be replaced. If no water flows but you can hear a humming noise, the water valve # W10159839 will need to be replaced. If nothing at all happens, some voltage checks will need to be made. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

 

 If you do not feel confident repairing this problem or doing any voltage checks yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services. If you need more assistance additional details will be helpful.

 

_Safety Notice_: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

 

Read More
Scott D -
Sears Technician
May 17, 2013
A:

I am having the same problem, but when I download the pictures, they are too small and get blurry when I enlarge. Can I get larger copies of the pictures?

Read More
Don -
September 24, 2015
See more answers
Q:

Ice Maker not working 10656703500 Kenmore Elite Side by side refrigerator

Q:

Ice Dispensing Motor Year 2006 Kenmore Elite 106.56703500 10656703500 Kenmore Elite Side by side refrigerator

A:

Thank you for choosing SearsPartsDirect.com and for contacting us with your question about your Kenmore Elite refrigerator model 106.56703500. I am so sorry the ice dispensing motor needs to be replaced.  I will be happy to help you with this. 

I have located the picture you requested and have included the image at the bottom of this post for you. 

SAFETY WARNING: Disconnect the power supply before beginning your project to prevent the risk of electrical shock which can result in property damage, serious personal injury or even death. Internal parts may have sharp edges. Use caution and wear work gloves to prevent serious cuts. If you are not comfortable completing this repair, you can set up service at www.SearsHomeServices.com or by calling 1-800-469-4663 (1-800-4MY-HOME).

I hope this answers your question. Thank you for choosing Sears, we appreciate your business. 

Read More
Rachel Morgan -
Sears Technician
August 12, 2015
A:
Rachel Morgan -
Sears Technician
August 12, 2015
See more answers

Top Parts