Model #10655519400 KENMORE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Parts Not Illustrated
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

My Kenmore Side by Side 106.55519400 bought in 1994 quit making ice. How do I determine if I need a new ice maker. There are no LED lights on it.

A:

Pull the cover off the front of the icemaker and you will see the module. It will have some test terminals on it and they will be marked (see picture). Use a well insulated jumper and place it between the T - H terminals. Be careful this is a hot (live) check. The icemaker should start into a cycle and if it does, remove the jumper after approx. 10 seconds. Now watch it cycle completely and toward the end it should fill with water. If it does fill, the icemaker # 4317943 will need to be replaced. It indicates it's not cycling on its own. If it doesn't fill and you hear a humming noise, the water valve # 4389177 will need to be replaced. If it won't fill and you don't hear anything, the jumper will be needed again. Place the jumper between the L - V terminals and water should flow to the icemaker. If no water flows and you don't hear anything, a voltage check at the valve will need to be made. First remove the jumper in the icemaker. To access the valve, pull the unit out far enough to remove the bottom panel cover. Now place your meter leads on the water solenoid that has the tan and white wires. Place the jumper back in the L - V terminals and the meter should read 120 volts. This check must be done with the wires still connected to the valve. If you do have the voltage, the valve will need to be replaced. If there is no voltage reading, it will indicate a possible break in the wires. A technician may be needed to verify this. If you need more assistance, please resubmit your question, with additional details. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Safety Notice: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Scott D -
Sears Technician
April 29, 2010

Top Parts