Model #10655514400 KENMORE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Parts Not Illustrated
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do I install a new ice door chute in the dispenser of Kenmore refrigerator?

A:

To access the ice chute, follow these steps:

  1. Unplug the refrigerator to completely disconnect electrical power.
  2. Remove the drip tray from the bottom of the dispenser.
  3. Pull the front cover (Key 23 in the image below) off of the dispenser. You may see 2 screws at the bottom of this cover when you pull the drip tray out. If not, then the cover is held on by clips. Pry out on the bottom of the cover to release the clips and snap the cover off of the dispenser.
  4. Pull the 2 screws (Key 22) out of the control bracket (Key 15) and pull this component outward. It will have wires attached to it.
With the control bracket pulled out, you should have room to remove and replace the door chute.

If you need more help with this repair, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
August 20, 2008
Q:

How do I install a new ice door chute in the dispenser of Kenmore refrigerator?

A:

To access the ice chute, follow these steps:

  1. Unplug the refrigerator to completely disconnect electrical power.
  2. Remove the drip tray from the bottom of the dispenser.
  3. Pull the front cover (Key 23 in the image below) off of the dispenser. You may see 2 screws at the bottom of this cover when you pull the drip tray out. If not, then the cover is held on by clips. Pry out on the bottom of the cover to release the clips and snap the cover off of the dispenser.
  4. Pull the 2 screws (Key 22) out of the control bracket (Key 15) and pull this component outward. It will have wires attached to it.
With the control bracket pulled out, you should have room to remove and replace the door chute.

If you need more help with this repair, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
August 20, 2008

Top Parts