Model #10654596400 KENMORE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Optional Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Hot surface!! 10654596400 Kenmore Refrigerator

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your refrigerator. Upon researching model 10654596400; the unit could have lint build up underneath. Clean out all lint from the back and underneath. Next check the condenser fan underneath. If the fan is not turning on it won’t cool the condenser. The center divider will hen act as a heat sink. I linked a diagram below. The fan is number 24.

Thank you for choosing Sears. Have a great day.     

Read More
Jeff Wallace Jr -
Sears Technician
October 15, 2014
Q:

Water filter 10654596400 Kenmore Refrigerator

A:

Thank you for your question and I understand wanting to know where the water filter is located.

The Kenmore water filter part #9030 or Whirlpool filter #4396710 is located under the left front area of the refrigerator. 

I added a link to the Use and Care manual and on page 12 it shows where and how to replaced the water filter.


Read More
Joey S -
Sears Technician
May 29, 2014
A:

When i looked were it was suppose to go, i didn't see were it connects too. there is some Styrofoam down there would that be were it would go?? Should i remove that??

Read More
Chad -
May 29, 2014
A:

Hello Chad, I added a link to the Use and Care manual based on the model number provided. If the water filter is missing and not installed, you should see where the water filter would be inserted. The instructions in the Use and Care should apply to the model number you provided. Was the water filter missing when you received the new refrigerator? If it was was purchased new and the water filter and the water filter housing is missing, call and set up service to have it repaired.

Read More
Joey S -
Sears Technician
May 29, 2014
A:

Chad, Does it appear the housing the filter would insert into is missing? Is there loose water lines with nothing connected? Maybe the filter housing is missing? You should not have to remove any Styrofoam to remove or install the water filter.

Read More
Joey S -
Sears Technician
May 29, 2014
A:

Ok thank you guys for your help.

Read More
Chad -
May 29, 2014
See more answers
Q:

Water line leaking on kenmore cold spot model number 106.54596400

A:

The ManageMyLife website is a great place to find answers to questions that need qualified and insightful responses. Some of these questions that are asked will need specific research and will be answered by an expert with-in two business days but usually sooner.

Read More
Dezeray S -
June 25, 2013
A:

Thank you for your question. The water fittings on this filter housing are the push/pull type fittings. I'm attaching a picture with instructions for this type of fitting. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
June 26, 2013
See more answers

Top Parts