Model #10653592300 KENMORE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Parts Not Illustrated
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Ice Maker

A:

An ice maker is an important feature on a refrigerator, when it stops working it can be frustrating.  While you are waiting for an expert to respond I was able to locate some great information that could possibly assist you with your issue.  I have added the link (click here). Hope this helps!

Read More
Yadira B -
June 19, 2013
A:

I know that it can be very frustrating to have issues with your ice maker This type of problem could be caused by the icemaker, the water valve or the temperature in the freezer. If the temperature gets above 5 degrees, the icemaker production will start slowing down. If the temperature is ok, to determine if the icemaker or water valve is the problem, the icemaker will need to be cycled. To cycle the icemaker pull the front cover off and you will see some test terminals. Now place a well insulated jumper between the T & H terminals (see picture). Be very careful this is a hot (live) check. This will cycle the icemaker and after the ejector has freed the cubes in the mold, remove the jumper. Towards the end of the cycle, it should fill with water for 7.5 seconds and get approx. 4.5 ounces of water. If the fill time is correct but the water fill is low or if you only hear a humming sound from the refrigerator, then the water valve will need to be replaced. If nothing happens, then the icemaker will need to be replaced. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
June 19, 2013
See more answers
Q:

No water, but ice coming OK

A:

Sorry I forgot to mention refrigerator. Kenmore Refrigirator- 10653592300

Read More
Aditya -
July 09, 2012
A:

I am sorry that you are having some difficulties with your water dispenser and I will be happy to help. I suggest you add to the thread of this question and include the full model number of your refrigerator so that the expert can provide you with a more detailed answer. I did manage to find a link that will guide you win making some checks. I hope this helps with your water dispenser troubles, while you wait for your expert response.

Read More
Joseph P. -
July 09, 2012
A:

Thanks for adding that model number.

That link for a previous answer that Joseph P. posted in the above response may help you fix the water dispenser problem. You could have a problem with a switch in that front dispenser or a failed water valve. A frozen water line could also cause that failure.

You can order parts from this page: Kenmore Refrigerator Model 106.53592300 Parts .

If you need more help, reply with additional details and we will assist you further.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
July 12, 2012
A:

Thanks for the response. I checked for the frozen water it the pipe. The water is not frozen in the pipe I am sure about that. Now question is (1) how to check the if switch is working or not. (2) how to check the if water valve is working or not.

Read More
Aditya -
July 17, 2012
A:

Hello Aditya. I posted a wiring diagram for your refrigerator with that circuit through the water dispenser switch and the water valve traced in wire colors. You can unplug the refrigerator and check the continuity through that switch in the dispenser using a volt/ohm meter. You should measure near zero resistance through that switch when the lever is activated and the lever on that microswitch is depressed. If that switch is working, you can check the continuity through the solenoid coil for the water valve. That solenoid will normally measure around 300 ohms. If that solenoid is open or shorted, then the water valve assembly will need to be replaced. If that solenoid resistance is okay, you will probably need to carefully check the voltage at that valve when the water dispenser lever is depressed. NOTE: You should only check that live voltage if you are completely confident in your technical ability to safely measure it using a volt/ohm meter. Wear electrical safety gloves and safety goggles when checking that live voltage. Unplug the refrigerator as soon as live testing is completed. If the valve is not getting voltage then you probably have a wiring failure in that circuit. These tips may help you further diagnose and repair that failure. If you need more assistance, let us know.

Read More
Lyle W -
Sears Technician
July 18, 2012
A:

Thanks for the posting the circuit diagram. Issue is resolved now. :-) Here is the steps I took to get to the bottom of the problem (1) See if the water is frozen in the pipe. I took a long plastic wire (lawn edger string) and inserted in the pipe to see if it get blocked [it was not blocked] (2) Verify the circuit. Voltage was correct all the points. Both the switch was working correctly (3) In the back where water solenoid was connected, checked the voltage it is was correct. Just to confirm that there is not break in the wires (4) Checked the continuity in the solenoid. One of the solenoid was broken (no continuity) replaced the solenoid water valve (got the part form amazon) and it got the water back. Feels good after fixing the problem. Thanks again

Read More
Aditya -
August 31, 2012
A:

Hello Aditya. Thanks for posting those details. That can help others who face this problem. We are glad to hear that your water dispenser is working again. Let us know if you ever need more assistance.

Read More
Lyle W -
Sears Technician
August 31, 2012
See more answers
Q:

running watts & max surge wattage for my 2003 kenmore fridge-freezer model #106.53592300 serial # sp3147548.Thanks for your help.

A:

I'm sorry to hear that you are having some difficulties with your refrigerator. I did some research for you at Managemylife.com and found the owners manual of your appliance in where you can find some detailed information about your refrigerator. I hope this helps until your expert can respond to your specific question. The link is attached below.

Read More
Joseph P. -
October 24, 2011
A:

Thank you for your question. I'm attaching the information for the normal wattage and also when it goes into the defrost mode. The surge wattage will be slightly more than the defrost wattage of 650 but it will only be for a couple of seconds. I hope this will help you.

Read More
Scott D -
Sears Technician
October 26, 2011
See more answers

Top Parts