Model #10652584202 KENMORE Side-by-Side Refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Freezer Liner
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Air Flow
    3 Results
  • Control
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

What is the capacity of this model? 10652584202 Kenmore Refrigerator

A:

Thanks for the inquiry and for being a valued member.

Based upon our records for this model of Kenmore refrigerator, we show this unit features 25 cu/ft. of capacity. 

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
May 04, 2015
Q:

Kenmore Refrigerator Coldspot 106.52584202 Energy Use

A:

With the cost of energy use going up it makes sense to know how you are doing with the Kenmore refrigerator. An expert will research this information and respond within 24-48 hours.

Read More
Anna T -
July 03, 2012
A:

Thank you for your question. This is a good question. The energy use of this refrigerator is going to be 590 kwh estimated yearly electricity usage. This is only the average and will vary depending on climate and usage, things like how often doors are open and for how long. This is slightly higher than todays models. The refrigerator was run down the assembly line in 2002 according to the model number 106.5 2 is the year so this is what I used for usage. I hope this information helps you out. If you have more questions, just reply to this thread

Read More
Bill__W -
Sears Technician
July 05, 2012
See more answers
Q:

my refrigeratos is freezing and the refrigerator side is not cooling

A:

A refrigerator is a very important appliance. So it is important to have this appliance working properly at all times. Below I have attached some expert answers from previous posts. I hope these links help and your refrigerator issue gets resolved!

Read More
Jackie S -
February 27, 2011
A:

I know it's frustrating when the refrigerator stops cooling. You have received some good information. Based on the information listed, it appears this may be a defrost related problem. If you are checking the heater and bi-metal it leads me think there must be a frost build up in the freezer, which will cause the fridge section to stop cooling. If you made the continuity check on the bi-metal while there was still ice on the coils and around the bi-metal and it showed no continuity, then the bi-metal # 2321799 is defective and will need to be replaced. It�s available at SearsPartsDirect . If you are making this check while the freezer section is warm or no frost on the coils, the bi-metal will be open or show no continuity. I hope this helps you. If you would like more assistance, any additional details will be helpful and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
February 28, 2011
A:

Thanks for you information i went back to check the bi metal defrost when the freezer was cold and i do have continuity, my fan is working as well, what will be my next step? also can you tell me how to replace the defrost heater. Thanks

Read More
Marco -
March 02, 2011
A:

You have indicated the heater element had continuity when you checked it, which indicates it's ok. However, if you would like to replace it, first disconnect power from the unit. The element is held in place with clips at the bottom. Free the element from the clips, disconnect the wires and the element will come out. Now, if frost is building up on the back wall in the freezer and based on the information already listed, I would suspect the defrost control board has failed. A good check will be to manually advance the board and put it into a defrost cycle. If the freezer is still cold (freezing) the following steps must be done in order to put this into a defrost cycle. 1. Unplug the refrigerator. 2. Turn the thermostat off. 3. Plug the power cord back in (leave the thermostat off). After a few minutes if you can hear a hissing sound or see a red glow in the freezer, it indicates the element is on. In this case the defrost control board # W10353224 will need to be replaced. If there is no frost building up in the freezer, then this will not be a defrost problem. I hope this will help you.

Read More
Scott D -
Sears Technician
March 03, 2011
See more answers

Top Parts