Model #10652564100 KENMORE Side-by-Side Refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Refrigerator Shelf
    3 Results
  • Freezer Liner
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Air Flow
    3 Results
  • Control
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

ice maker 10652564100

A:

Thank you for choosing Sears Parts Direct. I can certainly understand how frustrating it can be when your ice maker is not making any ice. I did look into the model number you have provided and I have found information that will assist you. I recommend testing the ice maker to see what is wrong.
 
1. Check the temperature of the freezer becasue if it is fewer than 17 degrees F it wont make ice. 
2.Check if your water fill spout is plugged with ice, if it is then it wont make ice.
3. Check to see if water is getting to the water inlet valve. 
4.Use an OHM meter to check the continuity of the water inlet valve. If it does not have any continuity then you need to replace your water valve. If it does then the icemaker itself is the problem and may need to be replaced.

You can also visit searpartsdirect.com for parts, diagrams, and repair information.
 
 
If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services.

Thank you for your question. Have a great day. 

Read More
Natasha12 -
Sears Technician
July 24, 2014
Q:

how to replace extention, part #2172932 10652564100 Kenmore Side-by-side refrigerator

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Henry -
July 12, 2013
A:

Thank you for contacting SearsPartsDirect.com with your question about how to clear the drain tube on your Kenmore Refrigerator. I am so sorry to hear that it is leaking and that the leak has caused floor damage. I can understand your desire to get this corrected. I will be happy to help you with this.

To help you see the parts I am referring to, I have included the link for the parts diagrams for your refrigerator.

Parts Diagrams for Kenmore Side-by-Side refrigerator Model 106.52564100.

Safety Warning. Before beginning your repair, disconnect power to the refrigerator by either unplugging it from the wall, or turning off the power source at the breaker. I recommend you also turn off the water supply to the refrigerator.

First remove and clean the evaporator tray (key 25 on the Unit page). It is on the bottom of the refrigerator behind the toe grille (key 15 of the Cabinet diagram). Replace the cleaned tray and then pull the refrigerator away from the wall. To access the extension tube you will need to remove the unit cover on the back of the refrigerator. The cover is key 21 on the Cabinet diagram. The extension tube is held in place by the drain extension flapper (key 34) and the drain tube clip (key 20). You can clean the tube with a solution of 50% warm water and 50% bleach. Be careful with the bleach as it can damage you skin and also the floor. If you see any cracks in the tube, or it doesn't come clean, you will want to replace it. I have included the link to order the part.

Extension Tube for Kenmore Side-by-Side refrigerator Model 106.52564100.

Next, I recommend you locate the drain hole inside of the freezer section. You will need to remove the bottom freezer basket. If you do not see it on the floor of the freezer, then it may be behind the Evaporator Cover (see key 17 of the Air Flow diagram). The drain hole will need to be cleared as well. Use the same 50% warm water and 50% bleach solution. To make it easy to pour the cleaning solution in the drain tube, use a turkey baster. Cleaning the drain system should be a part of your regular refrigerator maintenance. A good reminder is when you clean the condenser coils, clean the drain at the same time. I have included the link for a coil brush in case you don't have one. It will have the instructions on how to clean the condenser coils.

Coil Brush

Once the drain hole is clear, reattach the extension tube and replace the unit cover. Before pushing the refrigerator back in place, be sure to restore the water supply and the power. 

While you are completing your repair, I recommend you also replace the water filter. An old water filter can also cause build up in the water tubes and can also cause leaks. I have included that link for you also.

Water Filter for Kenmore Side-by-Side refrigerator Model 106.52564100.

I hope this answers your questions. If I can be of further assistance please respond to this thread. Thank you for choosing Sears, we appreciate your business.

Read More
Rachel Morgan -
Sears Technician
July 12, 2013
See more answers
Q:

Ice in bottom of freezer

A:

Thank you for your question. I see that you attempted to submit a question. For some reason the details did not post. If you could please reply below with the model number, Your expert will be happy to help you. It may take two business days for your expert to reply. I do hope that everything works out on the freezer.

Read More
Marc -
July 09, 2013
A:

Model #10652564100-- side by side frig. Ice is building up in the bottom of the freezer.

Read More
Paula -
July 09, 2013
A:

Thanks for contacting manage my life about your refrigerator ; sorry to hear you are having this problem I will be glad to assist. If I understand you correctly the water forming is in the freezer bottom. If there are no leaks in the ice maker or connecting tubing the only other source of water would be from the evaporator when it defrost several times a day. There is a drain trough under the evaporator coil that catches the defrost water and drains it to under the unit to a defrost drain pan where the water will evaporate from the heat of the condensing unit. The problem will be the drain trough under the evaporator coil is clogged and blocking water flow to the pan under the unit. You may first try this :Completely defrost all the ice by disconnecting power open doors, and allow 10 to 12 hours to melt(be ready to clean up water )After all the ice has melted away access the back of unit and remove the condenser cover, look for a drain tube just above the drain pan. Use air pressure to flush it clear. (Keep in mind any debris will push back into the inside of the drain trough under the evaporator. This will solve the issue the quick way but may reoccur over time. The other option would be accessing the trough by removing the evaporator cove in back of freezer section and clear it from the inside same way as from outside method, (Air pressure) reassemble in reverse order of disassembly.  I hope this helps, if you need additional help please reply with added details and I will be happy to respond. If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services.Ron H.      

Read More
Ron H -
Sears Technician
July 10, 2013
See more answers

Top Parts