Model #10651564103 KENMORE Side-by-Side Refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Refrigerator Shelf
    3 Results
  • Freezer Liner
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Air Flow
    3 Results
  • Control
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Refridgerator Door Seal 106.51564103

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Kenmore refrigerator.

From the information you have provided above, after researching model number 106.51564103. There aren’t any other parts needed for the replacement. The seal is the only part you need to get the job done. Below I have linked some information that may help you with the repair.

Click here.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

Read More
Benny23 -
Sears Technician
April 04, 2015
A:

Simple Fix.. just make sure the door is closing properly. I just swapped seal in 15 minutes and it didn't do trick. Noticed freezer door rises and then falls when opens and closes. Fridge side isn't. Seems the door cam is popular part. Might that be my problem.. we shall see. I guess a new seal is good but for a hundo, now I have to make this work or wife will kill me.

Read More
Frank -
April 15, 2015
See more answers
Q:

I have a Kenmore md# 106.51564103 my ice maker will not fill up with water to make cubes I bought a new module already I am geting pressure frm water line ,

A:

When in need of a nice cold beverage an ice maker that works properly is definitely in need so I understand the importance of having yours running soon. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. Have a great day!

Read More
Alina F. -
May 11, 2012
A:

Thank you for your question. I know it can be disappointing when the icemaker stops working. The icemaker in this model can stop working for a few reasons. Some are listed below:

  • The icemaker itself can fail
  • The water valve may not open
  • The optic boards can fail
  • The fill tube can freeze up
  • Freezer temperature not cold enough (should be 0 � 5 degrees)
The blinking led light can be flashing a code that will indicate the problem. If it flashes 2 times pauses and continues this while the door is open, it will be normal and if it stays on continuous, when the flapper door on the left side is held in, it indicates the boards are ok. I�m attaching a chart for the led indicator. When checking this icemaker, tape the little flapper door shut and disconnect power to the refrigerator. To check this icemaker, slide it out, so the front cover can be removed, to access some test terminals. There is a clip located on the back right corner of the icemaker that will need to be removed, to slide the icemaker out. There will be a screw at the bottom of the clip holding it. I�m sending a picture with instructions to remove this clip. With the clip removed, slide the icemaker out and remove the front cover. You will now see the test terminals, which are marked (see picture). Now remove the 3 screws holding the receiver board on the right side pull the board out and disconnect the harness from the board. Place a jumper between the black and black/white wires (see picture). Now use a second jumper and place it between the L � V terminals on the module. Reconnect the power and with both jumpers in place, water should now flow to the icemaker (be prepared to catch water from the fill tube). If water does flow, the icemaker # 2198597 will need to be replaced. If no water flows but you can hear a humming noise, the water valve # W10408179 will need to be replaced. If nothing at all happens, some voltage checks will need to be made. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

If you do not feel confident repairing this problem or doing any voltage checks yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services . If you need more assistance additional details will be helpful.

Safety Notice: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Scott D -
Sears Technician
May 14, 2012
See more answers
Q:

I need manual for ice dispenser for Kenmore side-by-side refrigerator 106.51564103 to learn why it has stopped making ice. It is dispensing water.

A:

I can understand your frustration over the issue that you are having with the ice maker. I was able to place some attachments down bellow that should be helpful.

Read More
celene -
December 03, 2010
A:

We don't have a manual for repairing the ice dispenser. I am sending you some images showing how to test the optics on the refrigerator.

If you have more questions reply on this thread and we will try to help.

Read More
Jimmy K -
Sears Technician
December 04, 2010
See more answers

Top Parts