Model #10651264101 KENMORE Side-by-Side Refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Refrigerator Shelf
    3 Results
  • Freezer Liner
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Air Flow
    3 Results
  • Control
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Icemaker not filling with water 10651264101 Kenmore Side-by-side refrigerator

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your fridge and I do understand your frustration. Glad to help out. I'm looking at your model number 10651264101 and an icemaker not filling can be due to the icemaker itself, the water valve or in this model a diode. First cycle the icemaker manually and watch to see if it fills. To cycle this icemaker, pull the front cover off. You will now see a large and small gear. Turn the small gear counterclockwise and the icemaker should start. If it does fill, it indicates the icemaker is not cycling on its own and will need to be replaced. The icemaker can also be cycling but not sending a voltage signal to the water valve, to fill. If it is sending a voltage signal, the problem will be with either the water valve or the diode. A volt/ohm meter will be needed. Here is a video that will help with the testing. 


There are some test terminals on this icemaker module, that can help determine, what the problem is. To access the module, pull the front cover off of the icemaker. You will now see the module and the test terminals will be marked. Use a well-insulated wire and place it between the L-V terminals. Be careful this is a hot (live) check. With the jumper in place, water should flow to the icemaker. If water does flow, the icemaker will need to be replaced. If no water flows, make sure temperature to freezer is not too cold, the water valve will probably need to be replaced. A voltage check needs to be made to determine for sure. With the jumper in place, check voltage at the valve. The wires must still be connected to the valve, when making this check. If there is still no voltage at the valve, it will indicate a broken wire in the cabinet. In this case, it's not repairable. I recommend having a technician check to verify, if this is the case.  Just click the blue link above to be taken to the page. If you have further questions please resubmit your question for further information.

 

Thank you for choosing Sears PartsDirect.com.

 

 

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
August 05, 2014
Q:

why do I keep wearing down the door closure cams? 10651264101 Kenmore Side-by-side refrigerator

A:

Thanks for your question- we see that no one from the community responded.  If you still require assistance on this topic, please resubmit your question with any updated information and we will have one of our experts take a look.  Also, we have updated our site to include information regarding common repairs and diagnosis, which can be found here: www.searspartsdirect.com/repair-help.html.  If you are looking for your owner’s manual, it can be found here: http://www.searspartsdirect.com/partsdirect/user-manuals.  Thanks for visiting SearsPartsDirect.com.

Read More
Natasha12 -
Sears Technician
December 05, 2013
Q:

Where can I get a reducer fitting for the water line?

A:

Normally most hardware stores will carry this type of fitting. If you cannot find one, a 5/16 x 1/4 reducer fitting # 4318044 is available at SearsPartsDirect . If you need more assistance, please resubmit your question with additional details.

Read More
Scott D -
Sears Technician
December 09, 2009

Top Parts