Model #10651254104 KENMORE Side-by-Side Refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Refrigerator Shelf
    3 Results
  • Freezer Liner
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Air Flow
    3 Results
  • Control
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I removed icemaker to clean and now it does not make ice 106.51254104

Q:

Freezer not dumping ice, why?

A:

I use ice for most of my beverages and I know how important it is to have a good working ice maker in your home and I will be happy to help. While you are waiting for an expert answer, I did manage to find a link that will provide you with some good information to help troubleshoot your problem. I hope my link is useful.

Read More
Joseph P. -
March 28, 2011
A:

Thank you for choosing Manage My Life. If there is ice in the mold and it's not harvesting it, I recommend first checking the freezer temperature. The normal temperature should be between zero and five degrees. If the temperature gets above 5 degrees, the icemaker will slow down and above 10 degrees, it may not work at all. To properly check the temperature, place a thermometer between some packages. Air temperature is not a good check. If the temperature is ok and the light is flashing normal as listed, the icemaker will probably need to be replaced. A good check will be, to use the test terminals on the icemaker module. To access the module, the icemaker will need to be pulled out, so the front cover can be removed. There is a clip holding the icemaker, which will need to be removed.

I'm sending a picture with instructions to remove this clip. With the clip removed the icemaker will slide out and you can pull the front cover off. You will now see the test terminals (see picture) and a well insulated jumper will be needed. Be careful, this is a hot (live) check. Place the jumper between the T - H terminals and now press in and hold the small flapper door on the emitter board and keep it held in. If the icemaker now cycles, remove the jumper after approximately. 10 seconds and watch it finish the cycle. If it completes the cycle and fills with water, it will verify the icemaker will need to be replaced. I hope this will help you. If you would like more assistance, additional details will be helpful and I will be glad to assist you further.

Read More
Rgabriella02 -
Sears Technician
March 29, 2011
See more answers
Q:

Why would I have to tap on the control housing to get my refrigerator to run?

A:


According to the description of your details it indicates a loose connection or a cold control/thermostat problem.

First, unplug the refrigerator or disconnect power.

Below are the steps to remove the control housing to check for any loose connections:

  • Pull both of the control knobs off the control housing in the fresh food section.
  • Carefully pry the face plate off the control housing.
  • Remove the two 1/4" hex head screws located behind the face plate facing you.
  • Remove the two 1/4" hex head screws at the rear of the control housing facing down.
  • Drop the control housing and check for any loose wiring connections.

I recommend calling a service technician to diagnose and repair your refrigerator.

Read More
expert -
Sears Technician
November 06, 2007

Top Parts