Model #10651212100 KENMORE Side-by-Side Refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Refrigerator System
    3 Results
  • Freezer Liner
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Air Flow
    3 Results
  • Control
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do you remove the metal wing on the motor that turns the ice dispensor shaft. model 10651212100

A:

First disconnect power to the unit. Remove the bucket assembly to access the motor. It's easiest to use a couple of channel lock pliers. You will need to grip and hold the motor shaft with one to keep it from turning. Use the other one to turn the coupling. The coupling will have reverse threads, so to remove it, turn the coupling clockwise. If it's stuck, tap on it to help get it started. If you need more assistance, please resubmit your question, with additional details.

Read More
Scott D -
Sears Technician
May 12, 2010
Q:

Why won't the icemaker fill with water?

A:

This can be a problem with either the icemaker or the water valve. This icemaker module has some test terminals that may help determine what the problem is. To access the module, pull the front cover off of the icemaker (see picture) and you will see the module. The terminals will be marked (see picture). Now use a well insulated jumper and place it between the L - V terminals. Be careful this is a hot (live) check. With the jumper in place, water should flow to the icemaker. If it does flow, the icemaker # 4317943 will need to be replaced. If no water flows but you can hear a buzzing noise, the water valve # 4389177 will need to be replaced. If nothing happens, some voltage checks will need to be made. A technician may be needed to make these checks. If you need more assistance, you can resubmit your question with more details. Both of these parts are available at SearsPartsDirect . If you need more assistance, you can resubmit your question with more details

Read More
Scott D -
Sears Technician
December 11, 2009
Q:

Why can't I lock the filter in place with the new cap?

A:

I suspect the filter is not engaging properly in the housing creating this problem. This could be due to the filter or the filter housing. If you have tried a couple of filters now and both have the same problem, the housing may have an internal problem and is not allowing the filter to seat properly and turn. I suggest replacing the filter housing #2186443. This housing is available www.searspartsdirect .com .

Read More
Scott D -
Sears Technician
April 20, 2009

Top Parts