Model #10650524102 KENMORE Side-by-Side Refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Freezer Liner
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Air Flow
    3 Results
  • Control
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Ice maker problem 10650524102 Kenmore Refrigerator

A:

Thank you for choosing SearsPartsDirect.com. I will be more then happy to assist you. The water inlet valve is what opens up and puts the water into the icemaker. The icemaker dose have a adjustment screw on it to make the water level persist. Its not enough of an adjustment to have small ice cubes or too much water were is overflowing. Hope this information helped in some way. If you are not comfortable doing this repair you can Click Here to schedule a technician or call toll free 1-800-469-4663. Hope this information has help you, any further questions or concerns please feel free to comment back, thanks.

Read More
Samantha A -
Sears Technician
May 28, 2014
Q:

Why does my Kenmore Coldspot side by side refrigerator model #10650524102 automatic ice maker not make ice fast enough?

A:

General Information

Most refrigerator ice makers fill on a "timed" cycle. Starting at the rear, each section fills, then spills over into the next, etc, until all sections are full. With low water pressure, the ice maker may only get enough water to fill a few sections leaving the rest empty, and thus not enough ice. Sections that barely get any water will make "hollow" cubes which can easily jam the ice maker. Check the following items and correct as necessary.

  • Low household water pressure - Water pressure to refrigerator should be at least 30 psi. You can check for adequate water pressure and flow. If you already have a refrigerator installed which has a water dispenser, you should be able to dispense about 3 to 6 ounces of water in about 5 seconds from your dispenser. -- contact a certified plumber if your water supply does not meet these conditions.
  • Clogged water filter - Replace water filter every 6 months, or sooner, as needed (depending upon water conditions).
  • Kinked tubing - Re-route plastic tubing to remove kink. Copper tubing cannot be unkinked.

  • Water supply connected to a reverse osmosis filter - Remove refrigerator water supply from reverse osmosis and connect to standard household water.

If you need further assistance you can re-submit your question with additional details.

Read More
Tammy S -
Sears Technician
February 18, 2010

Top Parts