Model #10645433800 KENMORE ELITE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Refrigerator Shelf Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Question and Answers

Q:

What is the energy use in Kwh for a Kenmore Elite refrigerator model 106.45433800

A:

The kilowatt hrs. per yr. is 557 per the sales information for this model. This can vary, depending on the usage and conditions. If you need more assistance, please resubmit your question, with additional details.

Read More
Scott D -
Sears Technician
May 27, 2010
Q:

What is wrong with the ice dispenser chute door on my Kenmore Elite refrigerator?

A:

In some models, the chute door won't close properly due to a broken tab. This would be a tab molded into the housing. In other models, a solenoid assembly can keep it from closing. If the chute door does not close well, ice cubes that get caught in the chute will fall out. Water can also drip out due to the ice in the chute.

Here is the procedure for accessing the internal parts of the dispenser:

  1. Disconnect electrical power to the refrigerator by unplugging it.
  2. Remove the OVERFLOW GRILLE (KEY #9) from the bottom of the dispenser.
  3. Remove the 2 screws that hold the FRONT COVER (KEY #21) to the dispenser housing.
  4. Lift the FRONT COVER up and off. It will have several wires connected to it. You should be able to complete the work without disconnecting these wires. If you do need to disconnect them, pay close attention to the location of the wires so that they can be replaced properly. Move or position the front cover out of the way.
  5. Remove the 2 screws (KEY #22) that hold the CONTROL BRACKET (KEY #15) to the dispenser housing. Pay close attention to how the CONTROL BRACKET is positioned in the dispenser housing. It will need to be replaced properly.
  6. Pulling the CONTROL BRACKET out should give you access to the internal parts of the dispenser.
You should be able to determine which parts are broken and need to be replaced. Reassemble the dispenser in reverse order.

If you require further assistance please resubmit question with more details. I will be looking forward to helping you again in the near future.

Read More
Landell -
Sears Technician
February 17, 2010

Top Parts