Model #10080 NIKKO Radio/remote control toys

  • Replacement Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

how to install ge we19x10080 control board

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina -
October 06, 2012
A:

The procedure for installing that control board is shown in the images below. The 4th image shows a wiring diagram for your dryer. Be sure that you unplug the dryer before accessing internal components.

If you need more help, reply with additional details and we will assist you further.

If you get to the point where you need to have a service technician replace that control board, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
October 09, 2012
A:

Here is the 4th image.

Read More
Lyle W -
Sears Technician
October 09, 2012
See more answers
Q:

how to install part #wr24x10080

A:

When looking to find some tips on how to replace a part, Manage My Life is here to help. I suggest you add to the thread of this question and include the full model number of your refrigerator so that the expert can provide you with a more detailed answer. I am adding a link below to guide you with your project. I hope this helps while you wait for your expert response.

Read More
Joseph P. -
September 22, 2011
A:

Thank you for your question. Replacing some parts can be a little tricky sometimes. Unfortunately, the model number listed is not showing to be a valid model but by altering it slightly, it does bring up several models. This appears to be a one piece door and the gasket in this type of door is a push in and pull out style. This gasket has a lip that will fit in a groove in the door panel. To remove the original gasket, it's usually best to start in the middle and pull the gasket out. To replace the gasket start at the top corners and push the gasket back in place. I hope this will help you. If you would like more assistance, reply to this thread and please recheck to verify the model number and I will be glad to assist you further. Thank you for using Manage My Life.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
September 26, 2011
See more answers
Q:

my kenmore dishwasher won't drain the water out

A:

It sounds like the dishes are very clean even if not rinsed or dried. While you wait for the expert to review your model, I did find a similar question that has some possible causes you can check if you like. I attached the link below. I also added the link to Sears Home Services, if you decide it would be simpler to have an expert technician visit to diagnose and make repairs. Hope this helps!

Read More
Barbara H. -
December 18, 2010
A:

If it never drains the water out and the timer never advances and runs all night I suspect the problem is caused by a bad timer.

The timer is used to stall the cycle for water heat and then advance on. If the timer never advances then most likely the timer is at fault.

There is a drain solenoid that is activated with 120 volts from the timer. Try turning the timer slowly and see if the solenoid ever gets activated.

If it never activates then the timer is most likely at fault.

The timer WD21X10080 can be obtained from the following site: Sears PartsDirect .

I hope this information is helpful to you in resolving this problem. You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
December 20, 2010
See more answers