Model #0995 POWERWHEELS/PINES Toy riding

  • 12 Volt
    3 Results
Find part by diagram >

Question and Answers

Q:

Bob Blanchette: we installed the rpm sensor on garage door opener; now we need help reinstalling the chain and adjusting.

A:

Undertaking repairs on a garage door can be tricky. Congratulations on getting that sensor replaced. To help with the chain and adjustments, I found a great article on installing garage doors that may help you continue with this project. It may at least get you started while you wait for the expert. A suggestion I have to help the expert provide better instructions is to add the garage door opener model number to this thread. Hope this helps!

Read More
Barbara H. -
October 07, 2010
A:

Thank you for your question.

With out the model number of the garage door opener I can only give you a general answer.

  • I can direct you to the Manage My Life site where we store the Owner/Installation manual's.

  • If you put your model number in the manual tab it should give you the procedure for that model.

  • Because of the design change some years ago I will try to address both style chain drive systems.

These links to the manuals should help you.

Pick the one that looks like your rail style.

The first manual is for the older T Rail style chain drive opener GDO MANUAL .

This one is for the box rail style opener Box rail type GDO owners manual .

In the owners manuals they have all the installation and adjusting of the chain tension.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
October 08, 2010
A:

My garage door opener is model# 159.53635SRT HP is 1/2 Mfg date 09/95

Read More
harry -
October 08, 2010
A:

Thank you for the model number. 139.53635SRT. The steps for putting the chain on and getting it correctly adjusted for your T rail style, is contained in the owners manual on steps four and five on the assembly pages. I will add the link for the manual. Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
October 08, 2010
A:

The instructions in steps 4 and 5 are for a new opener that has not been run. To get your opener in this condition you must run the motor and watch the sprocket on top of the motor unit. Run the motor until the sprocket runs in the clockwise direction and stops. Then install the chain per instructions.

Read More
Don -
October 08, 2010
See more answers
Q:

Helpful article. But where do I find a manual for this?

A:

I will need a more detailed email with the model number to help you with your question.

Read More
Jerome G. - Personal Solutions Manager -
Sears Technician
June 09, 2010
A:

The model number of my garage door opener (installed during the late 80's is 159.53635SRT with a HP of 1/2 and a mfg date of 09/95

Read More
harry -
October 08, 2010
See more answers