Model #0124 POWERWHEELS/PINES Toy riding

  • Replacement Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

fault codes for my frigidare gallery dishwasher FGHD2465NF1A Frigidaire Dishwasher

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you.

These are the only error codes I am seeing for this model.


PF..........A power failure has occurred
Hd or HO.........Water heating delay
CL..........Close and latch the door
‘01-24’- ...Hour(s) delay before Start (some models)
ER/ER....Switch Failure
ER/CE....Configuration Error
ER/uo.....Vent will not close
ER/uF.....Fan not running

SENSING- ---------------------- Turbidity sensor is checking the condition of the wash/rinse water. No sensing for LIGHT WASH (UPPER RACK), LIGHT WASH (LOWER RACK) and CHINA/CRYSTAL.
WASHING- ---------------------- Wash portion of cycle.
SANITIZED--------------------- The SANITIZED criteria has been met. 
DRYING------------------------ Drying portion of cycle. Indicator light will switch off when door is opened.
CLEAN------------------------- Shows completion of cycle. Indicator light will switch off when door is opened.
OPTION LED's Flashing
-- HI-TEMP WASH and NO HEAT DRY/POWER DRY OFF LED's flashing indicates power failure has occurred. 


You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
July 26, 2015
Q:

Not restarting

A:

I know that it can be very inconvenient for you not to have your tiller working properly.  While you are waiting for an expert to respond I was able to locate some great information that could possibly assist you with your issue.  I have added the link. Hope this helps!

Read More
Yadira B -
April 28, 2013
A:

Your symptoms point to a problem with the carburetor. You could have a partial blockage in that main jet. I recommend that you clean the carburetor. 

 

Here is a link for the parts diagram on the engine for that tiller: Briggs & Stratton Engine 121432-0124-E1 Repair Parts.

 

Here is a link for the parts for the tiller: Craftsman Tiller Model 917.293320 Repair Parts.

 

If you need to have a service technician examine and repair the tiller, you can arrange service through this link: Sears Home Services Tiller Repair.

Read More
Lyle W -
Sears Technician
April 30, 2013
See more answers
Q:

I have a model 917293310 tiller about 9 years old. The carb. will not come clean and will only run on choke.

A:

If your engine is a Briggs and Stratton model 121432-0124-E1, you need carburetor number 698479. If your engine is a different model number and you looked up the part number for the carburetor, order the 498479.

The carburetor prices go up as they get older and there are fewer in stock.

Replacing the kit won't do any good unless you clean all the fuel and air passages inside the carburetor with a soft wire, carburetor cleaner, and compressed air to blow them out.

The best bet is to bite the bullet and order the complete carburetor.

Read More
Jimmy K -
Sears Technician
March 28, 2009